Sliding bearings are surface contact, so the contact surface to maintain a certain film, so the design should pay attention to the following questions:
1, to make the oil film can smoothly enter the friction surface.
2, the oil should be non-bearing surface area into the bearing.
3, do not make full-ring groove open in the middle of the bearing.
4, such as oil tile, seams open ditch.
5, to make oil ring full and reliable oil.
6, filling hole do not be blocked.
7, do not form the oil does not flow area.
8, to prevent sharp edges and edges cut off the film.
Post time: May-11-2018